Pairing Remote Control Emotion Control AFB2

Instructions

Pairing Emotion control remote control.

If you buy a new remote control or changed the battery of your current remote control, you need to pair the remote control with your receiver again.Follow these steps to pair the Remote Control Emotion Control AFB2.

Step 1.

For a new remote, remove the foil near the battery.

Step 2.

Unplug the receiver and plug it back in. Two things can now happen on the receiver. Either the blue control light is on constantly, or it flashes very quickly.

Step 3.

Whether the light blinks quickly or is already on constantly, the next action is the same. You now press the blue check light with a pen or paper clip. The light will now be constantly blue.

Step 4.

Now hold the remote close to the receiver and press the power button on the remote for 5 seconds. If the new remote control is connected you will see the blue control light blink once quickly. After this, the blue light goes out.
The remote control is now set and you can use it. Unfortunately we sometimes find that the first time it does not quite succeed with the pairing. You should then go through the steps again.
If it still does not work after several times? Then the receiver may be defective. You can no longer pair the remote control and will need a new receiver .